Thats just a beauty! I really should get my self an more accurate armor. Looking good, keep up the good work!

Looking good, man!

Update:

Belt, sniper knee and handplates not yet mounted. Still waiting on my pouches (any day now).


Pauldron test. Now I only need to cut and sand in a few spots where the pieces pinch.


Hey you, YES YOU!

Looking good! I would work a little more on the eyes, you look a little sleepy.

Thnx, but that was kinda the idea :P

Update

Everything in place. I just need to add velcro to the back of the (canvas) belt, add some foam inside the forearms and dye my pouches. That leaves weathering and my T-21 wich I'll start to work on in a few days. The backpack will have to wait for now.

Since Im almost done with my armor (weathering and a few minor tweaks to go) I started to do some serious work on my T21. Prior to the actual woodwork I did a lot of research and created a 3D modell from wich I made blueprints. Here are some shots from the work in progress.

My first dummy at the top. New "main body" to be cut out at the bottom.


Blueprint parts glued (spray glue) on a board to be cut out. Ive been using boards of various thickness for different gun pieces.


Various parts. Test fitting details on the main body.


Barrel parts. The front piece is separate from the main piece (it slides into the main piece) wich will allow me to mount electronics afterwards. The seam will be hidden underneath the front ring (wich holds the front sight). Rear sight at lower left corner.